Customer display pole

General Discussions
Post Reply
Papa-Enrico
Active Member
Active Member
Posts: 51
Joined: Sun Nov 10, 2019 10:47 am

Customer display pole

Post by Papa-Enrico »

Good day
i am having problems with my customer display pole (where it shows price). It worked well before I updated to license version, then it would freeze...now when I updated the mod to run with more stations, it doesnt work. It boots up but when I start POS it turns off. I checked the Customer display box and rebooted many times...any suggestions?
User avatar
Scott
Site Admin
Site Admin
Posts: 2566
Joined: Wed Apr 16, 2003 5:35 pm
Location: Western PA

Re: Customer display pole

Post by Scott »

Check the baudrate, com port and mode options for that station in the local config. Most displays run at 9600,8,N,1. Also try the different Command Type options. AEDEX is the best if your display supports it. You may need to change dip switches on your display or run a configuration utility if it uses one. ESC/POS should work for most non-AEDEX displays.

Scott
Post Reply