*READ* Before upgrading!!

General Seup or Installation Help
Post Reply
User avatar
Scott
Site Admin
Site Admin
Posts: 2566
Joined: Wed Apr 16, 2003 5:35 pm
Location: Western PA

*READ* Before upgrading!!

Post by Scott »

Before Upgrading:

Make sure that you DO NOT select the "Install Sample Data" option or your data will not be converted.

If this does happen to you take the following steps to correct this problem.
  1. Drop to the MS-DOS prompt and change directory to the DATA folder directly under the POS Pizza folder.
  2. Delete all .PZ5 & .CLK files using DEL *.PZ5 and DEL *.CLK from the command prompt.
  3. Change directory back to the main POS Pizza folder and then run Dcvt4to5 /L. This will force the conversion utility to convert your 4.0 data to the new v5.0 format.
Scott
Mike
Support Team
Support Team
Posts: 93
Joined: Wed Apr 16, 2003 6:51 pm

Post by Mike »

Also you should verify that your hardware is capable of running v5.x before upgrading! Version 5.x requires bigger hardware than v4 did. Please see the Hardware Requirements at our About POS Pizza web page.

Mike
Post Reply